Username = jamesmadisonmiddleschool

Password = @madison32796

1. Click the add model button

2. Select your "Downloads Folder"

3. Select your .stl file

4. Select Open

Our model is toooooo small

1. Click the "i" button

2. Select the drop down

3. Select Inches

1. Click on the "Orient" button

2. Click "Place Face on Build Plates"

1. Left click on the BOTTOM of your object (use the side because its a clean flat surface)

2. Click "Bottom" when the pop up appears

1. Click the arrange button

2. Click "Arrange Build Plate"

This will center your object on the build surface

1. Select the Gear to open up the sub menu

2. Click "Custom Settings"

1. Click "Base Layer"

2. Select the drop down for raft and select NONE

3. Hit Done

1. Press Export

2. Select the flash drive you plugged into the computer

3. name your gcode file to "lastname object"

example "aktas namecube"

4. Press Export

 Watch the video for detailed information.

WATCH THE VIDEO

Watch to make sure the 1st layer STICKS!!!!! if it does not please cancel the print.